Стандартные программы Windows

         

This switch is useful only


This switch is useful only to test device driver compatibility with large memory systems.

/NOPAE



Forces Ntldr to load the non-Physical Address Extension (PAE) version of the Windows kernel, even if the system is detected as supporting x86 PAEs and has more than 4 GB of physical memory.

/NOSERIALMICE=[COMx | COMx,y,z...]



Obsolete Windows NT 4 qualifier—replaced by the absence of the /FASTDETECT switch. Disables serial mouse detection of the specified COM ports. This switch was used if you had a device other than a mouse attached to a serial port during the startup sequence. Using /NOSERIALMICE without specifying a COM port disables serial mouse detection on all COM ports. See Microsoft Knowledge Base article Q131976 for more information.

/numproc=number

This switch sets the number of processors that Windows will run at startup. With this switch, you can force a multiprocessor system to use only the quantity of processors (number) that you specify. This switch can help you troubleshoot performance problems and defective CPUs.

/ONECPU



Causes Windows to use only one CPU on a multiprocessor system.

/PAE



Causes Ntldr to load Ntkrnlpa.exe, which is the version of the x86 kernel that is able to take advantage of x86 PAEs. The PAE version of the kernel presents 64-bit physical addresses to device drivers, so this switch is helpful for testing device driver support for large memory systems. Use the /PAE switch with the corresponding entry in Boot.ini to permit a computer that supports physical address extension (PAE) mode to start normally. In Safe Mode, the computer starts by using normal kernels, even if the /PAE switch is specified.

/pcilock

For x86-based systems, this switch stops the operating system from dynamically assigning hardware input, hardware output, and interrupt request resources to Peripheral Connect Interface (PCI) devices. With this switch, the BIOS configures the devices.

/RDPATH=



Specifies the path to a System Disk Image (SDI) file, which can be on the network, that the system will use to boot from.

Содержание  Назад  Вперед





Forekc.ru
Рефераты, дипломы, курсовые, выпускные и квалификационные работы, диссертации, учебники, учебные пособия, лекции, методические пособия и рекомендации, программы и курсы обучения, публикации из профильных изданий